Kubota B2910 User Manual

6 FRONT AXLE B2410· B2710· B2910 WSM, 12271
Case cover mounting
17.7 to 20.5
N·m
Tightening torque
1.8 to
2.1 kgf·m
screw
13.0 to 15.2 ft-Ibs
Shift Cam
1. Remove the case cover (2) with the shift lever and shift cam (5).
2. Remove the external snap ring (4) and collar (3).
3. Remove the shift lever (1) .
• NOTE
• The white marks is painted on the shift lever (1) for aligning
the shift cam.
(When reassembling)
• Apply liquid gasket (Three Bond 12080 or equivalent) to joint
face of the bi-speed turn case (6) and case cover (2).
• When installing the shift cam, be sure to align the marks on the
shift cam and shift lever.
12271F60220
SOOB177P336
2
(1) Shift Lever
(2) Case Cover
(3) Collar
(4) External Snap Ring
(5) Shift Cam
(6) Bi-speed Turn Case
12271860250
SOOB022P005
Shift Roller Shaft
1. Remove the cover (1).
2. Remove the nut (2) and the shift roller shaft assembly.
3. Tap out the shift roller shaft (3), while holding the bearing (5) to
remove the shift roller (6). The retainer ring (7) is mounted
inside of the roller.
(When reassembling)
• Apply liquid gasket (Three Bond 12080 or equivalent) to joint
face of the cover (1) and bi-speed turn case.
(1) Cover (5) Ball Bearing
(2) Nut (6) Shift Roller
(3) Shift Roller Shaft (7) Retainer Ring
(4) Adjusting Shim
12271860260
6-820

Kubota B2910 Specifications

General

Fuel Type	Diesel
Transmission Type	Hydrostatic
Hydraulic System	Open center
3-Point Hitch	Category I
Lift Capacity	1, 323 lbs (600 kg)
Drive	4WD
Engine Type	Diesel, 4-cycle, liquid-cooled
Horsepower	30 hp
Number of Gears	Infinite (3 ranges)
Wheelbase	63 inches
PTO Horsepower	22 hp