82410 • 82710 • 82910 WSM, 12271
G GENERAL
Changing
Transmission
Fluid
A CAUTION
• Be
sure
to
stop
the
engine
checking
and
changing
the
transmission
fluid.
1.
Place
an
oil pan under the tractor.
2.
Remove the drain plugs (1) at the bottom of the rear axle cases
and oil tank.
3.
Drain the transmission fluid.
4.
After draining, screw
in
the three drain plugs.
5.
Fill new oil from filling port after removing the filling plug
(2)
up to
the upper notch on the dipstick.
6.
After running the engine for a few minutes, stop
it
and check the
oil level again, if low, add oil prescribed level.
• IMPORTANT
• Use
only
mUlti-grade
transmission
oil. Use
of
other
oils
may
damage
the
transmission
or
hydraulic
system.
Refer
to
"LUBRICANTS AND FLUID" (See page G-8).
• Never
work
the
tractor
immediately
after
changing
the
transmission
oil.
Keeping
the
engine
at
medium
speed
for
a
few
minutes
to
prevents
damage
to
the
transmission.
• Do
not
mix
different
blands
oil
together.
12.5 L
82410 3.30 U.S.gals.
2.75 Imp.gals.
Affeted Serial No.: below 15496
14.0 L
3.70 U.S.gals.
Transmission fluid
82710
3.08 Imp.gals.
capacity
Affeted Serial No.: above 50101
14.5 L
3.83 U.S.gals.
3.19 Imp.gals.
14.5 L
82910
3.83 U.S.gals.
3.19 Imp.gals.
(1)
Drain Plug
(2)
Filling Plug
(3)
Dipstick
G-13
(A) Oil level acceptable
within
this
range.
12271
G00060
To Next Page
Loading...
Need help?
General
