GENERAL
B2650HSDC, B3350HSDC, WSM
G-19
[2] CHECK POINTS OF INITIAL 50 HOURS
Changing Engine Oil
To avoid personal injury:
• Be sure to stop the engine before changing the oil.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. To drain the used oil, remove the drain plug at the bottom of the
engine and drain the oil completely into the oil pan.
All the used oil can be drained out easily when the engine is still
warm.
2. After draining reinstall the drain plug.
3. Fill with the new oil up to the upper notch on the dipstick.
• Use DPF-compatible oil (CJ-4) for the engine.
9Y1210822GEG0022US0
Replacing Engine Oil Filter
To avoid personal injury:
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand and additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. then, replenish the engine oil up to the prescribed level.
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
9Y1210822GEG0023US0
Engine oil Capacity
B2650
4.0 L
4.2 U.S.qts
3.6 Imp.qts
B3350
4.8 L
5.1 U.S.qts
4.2 Imp.qts
(1) Dipstick
(2) Oil Inlet Plug
(3) Drain Plug
A : Oil level is acceptable within this
range.
[A] B2650
[B] B3350
(1) Engine Oil Filter
To Next Page
Loading...
Need help?
General
