Kubota BX2380 Installation Manual

DO NOT PROCEED FURTHER UNTIL YOU HAVE READ THE INFORMATION BELOW
1) Always wear personal protective equipment
2) A minimum of two people is necessary to safely install the cab
3) This ROPS cab is heavy. A lift assist device such as an overhead
hoist or high lift forklift is required.
4) Ensure your work area is well ventilated. The installation
requires the starting of the tractor which will produce
dangerous carbon monoxide fumes.
5) Read through the entire installation manual first.
6) Follow the installation instructions in order.
7) Reading the operators manual prior to using the ROPS cab.

Kubota BX2380 Specifications

General

Engine Model	D902
Displacement	54.8 cu in (0.9 L)
Engine Power	23 hp (17.2 kW)
PTO Power	17.7 hp (13.2 kW)
Transmission	Hydrostatic
Drive	4WD
Fuel Capacity	6.6 gal (25 L)
Hydraulic System	Open center
3-Point Hitch	Category I
Lift Capacity at 24"	680 lbs (308 kg)
Tire Size (Front)	18x8.5-10
Tire Size (Rear)	26x12-12
Engine Type	3-cylinder diesel
Wheelbase	55.1 in (1400 mm)
Weight	1433 lbs (650 kg)