PAGE 1
308955
DPF-MRK-003 REV A 1/15/18
PASSENGER ARMRESTS FOR TOURING & TRI GLIDE, CHROME 8955
866 277 9598 | INFO@KURYAKYN.COM
454 COUNTY ROAD VV SOMERSET, WI 54025
KURYAKYN.COM
INSTALLATION INSTRUCTIONS
THANK YOU FOR CHOOSING KURYAKYN!
Protect yourself and others from possible injury and property damage or loss. Pay close attention to all instructions, warnings, cautions, and notices regarding the installation, use, and care of this product.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN POTENTIAL DEATH OR SERIOUS INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN CAN RESULT IN MINOR OR MODERATE POTENTIAL INJURY.
THIS INDICATION ALERTS YOU TO THE FACT THAT IGNORING THE CONTENTS DESCRIBED HEREIN MAY NEGATIVELY AFFECT PRODUCT PERFORMANCE AND FUNCTIONALITY OR
DAMAGE THE PRODUCT ITSELF OR THE PRODUCT TO WHICH IT IS BEING ATTACHED.
ENSURE THAT THE FOLLOWING PARTS HAVE BEEN INCLUDED IN THE KIT:
1 Right-Side Mount 1 Right-Side Armrest Pad
1 Left-Side Mount 1 Left-Side Armrest Pad
2 Paint Protectors
YOU WILL ALSO NEED:
Set of sockets and ratchet, warm, soapy water and a clean rag, set of hex wrenches
THESE INSTALLATION INSTRUCTIONS CONTAIN IMPORTANT INFORMATION. ENSURE THE END USER RECEIVES THIS COPY AND IS AWARE
OF ITS IMPORTANCE FOR FUTURE USE.
STEP 1
Read and understand all steps in the instructions before starting the
installation. Park the motorcycle on a hard, level surface and turn off
the ignition. Let motorcycle cool.
INSTALL THE ARMREST MOUNTS:
STEP 2
Use masking tape to mark the Tour Pak® at the rearward edge of the
right-side speaker pod as shown in PIC 1. Repeat for the left side.
THE END USER’S SAFETY DEPENDS UPON PROPER INSTALLATION OF
THIS PRODUCT. IF A STEP IN THESE INSTRUCTIONS IS NOT WITHIN YOUR
CAPABILITIES OR YOU DO NOT HAVE THE CORRECT TOOLS, HAVE YOUR
DEALER PERFORM THE PROCEDURE. IMPROPER INSTALLATION OF THIS
PRODUCT COULD RESULT IN DEATH OR SERIOUS INJURY.
ACCIDENTAL VEHICLE START-UP COULD CAUSE DEATH OR SERIOUS
INJURY, REMOVE THE MAIN FUSE BEFORE PROCEEDING.
STEP 3
Open the Tour Pak™ lid.
STEP 4
On the front of the Tour Pak™, locate and remove the two Torx screws
shown in PIC 2. Removing the screws will release the tether anchor.
WITH THE SCREWS REMOVED, THE TETHER ANCHOR CAN RETRACT
RAPIDLY CAUSING DAMAGE TO THE MOTORCYCLE. SECURE THE TETHER
ANCHOR WHILE THE SCREWS ARE BEING REMOVED.
Note: Get someone to help secure the Tour Pak™ lid until the tether
anchor is reattached to prevent the lid from opening too far.
STEP 5
Remove the Tour Pak™ liner; pull upward on the rear of the liner to
remove it.
PIC 1
PIC 2
BRAKE-SIDE (RIGHT)
SPEAKER POD
TAPE
TETHER
ANCHOR
FRONT OF BIKE
REMOVE
TORX
SCREWS
To Next Page
General