Model: LTV-TH2
DC: 083017
Thermo-hygro Sensor
Power & Mounting
LED Light
AA
+
-
AA
+
-
Battery Cover
Hole for
mounting
TX
F/C
∙ Press TX to send a signal
∙ Press F/C to select Fahrenheit
or Celsius display on sensor.
1. Install 2-AA batteries according to polarity and replace battery cover. The blue LED light will flash
when transmitting.
Mounting:
1. Use the hole at the top to hang your sensor from the back using a nail. Or, insert one mounting screw
through the front of your sensor.
2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is
preferred to avoid inaccurate readings from the sun.
3. The maximum wireless transmission range to the weather station is up to 400 feet (121 meters) in open
air, not including walls or floors.
4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.
Note: Watch sensor mounting video: http://bit.ly/TH_SensorMounting
To Next Page
Need help?
General
