Page 2
It includes a programmable filter change reminder,
equipment maintenance reminder and a system check
indicator to notify the user when the equipment requires
service.
The remote indoor sensor when connected and configured
will act as a room temperature sensor instead of internal
temperature sensor available with the thermostat. The dip
switch is used to select either built-in or external remote
indoor temperature sensor used for temperature control.
WARNING
This product contains a chemical known to the State of
California to cause cancer, birth defects, or other
reproductive harm.
CAUTION
Do not short (jumper) across terminals on the gas valve
or at the system control to test installation. This will dam
age the thermostat and void the warranty.
IMPORTANT
Read all of the information in this manual before using this
thermostat.
All wiring must conform to local and national building and
electrical codes and ordinances.
This is a 24VAC low-voltage thermostat. Do not install on
voltages higher than 30VAC.
WARNING
Improper installation, adjustment, alteration, service or
maintenance can cause property damage, personal injury
or loss of life. Installation and service must be performed
by a qualified installer, service agency or the gas supplier
General
These instructions are intended as a general guide and do
not supersede local codes in any way. Consult authorities
having jurisdiction before installation.
Check equipment for shipping damage. If you find any
damage, immediately contact the last carrier.
To Next Page
Loading...
Need help?
General
