Page 1
UNIT INFORMATIONUNIT INFORMATION
Service Literature
CAUTION
As with any mechanical equipment, contact with
sharp sheet metal edges can result in personal
injury. Take care while handling this equipment and
wear gloves and protective clothing.
WARNING
Electric shock hazard. Can cause injury
or death. Before attempting to perform
any service or maintenance, turn the
electrical power to unit OFF at disconnect
switch(es). Unit may have multiple power
supplies.
Table of Contents
Options . . . . . . . . . . . . . . . . . . . . . .Page 2
Blower Data . . . . . . . . . . . . . . . . . . Page 6
Electrical Data / Electric Heat Data . Page 10
Outdoor Sound Data. . . . . . . . . . . . . Page 14
I Unit Components . . . . . . . . . . . . . Page 16
II Placement and Installation . . . . . Page 27
III Start Up Operation . . . . . . . . . . . Page 27
IV Charging . . . . . . . . . . . . . . . . . . . Page 28
V System Service Checks . . . . . . . Page 34
VI Maintenance . . . . . . . . . . . . . . . . Page 34
VIII Diagrams . . . . . . . . . . . . . . . . . . Page 43
packaged cooling units are available in standard cooling
gle or multiple stages depending on the kW input size.
KCC packaged cooling units.
tube coils.
ent energy management thermostat control systems with
tions connect to the unit with jack plugs. When ”plugged
subject to change. Procedures outlined in this manual are
presented as a recommendation only and do not super
sede or replace local or state codes.
WARNING
To prevent serious injury or death:
1- Lock-out/tag-out before performing maintenance.
2- If system power is required (e.g., smoke detector
maintenance), disable power to blower, remove
fan belt where applicable, and ensure all
controllers and thermostats are set to the “OFF”
position before performing maintenance.
3- Always keep hands, hair, clothing, jewelry, tools,
etc., away from moving parts.
WARNING
Improper installation, adjustment, alteration,
service or maintenance can cause property damage,
personal injury or loss of life. Installation and service
must be performed by a licensed professional HVAC
installer or equivalent, service agency, or the gas
supplier
KCC SERIES
7.5 to 12.5 ton
KCC092 through 150