19
208/230V Outdoor Unit
Terminal Block
From Power
Supply
1 2 3 L1 L2
Terminal Block
1 2 3
208/230V Indoor Unit
NOTE - Use minimum of 18 GA stranded wiring.
Outdoor Unit Indoor Unit
Figure 24. Single Zone Wiring
IMPORTANT
This unit must be properly grounded and protected by a
circuit breaker. The ground wire for the unit must not be
connected to a gas or water pipe, a lightning conductor
or a telephone ground wire.
Do not connect power wires to the outdoor unit until
all other wiring and piping connections have been
completed.
Do not install the unit near a lighting appliance that
includes a ballast. The ballast may affect remote control
operation.
IMPORTANT
All diagrams (Figure 25 through Figure 36) are typical
wiring diagrams. Refer to the wiring diagram on the unit
for actual wiring.
To Next Page
Loading...
Need help?
General
