E 2009 Lennox Industries Inc.
Dallas, Texas 75379-9900
This manual provides operation and maintenance
instructions for models RGEN12 and RGEN17/18
generator sets.
Generator sets are approved for use in stationary
standby applications in locations served by a reliable
utility power source. Have a Lennox dealer who is
approved to sell and install Lennox generator sets
(hereinafter referred to as a Lennox dealer) install the
generator set. Refer to XP-6514, Installation
Instructions, for installation instructions.
Information in this publication represents data available
at the time of print. The manufacturer reserves the right
to change this publication and the products represented
without notice and without any obligation or liability
whatsoever.
Read this manual and carefully follow all procedures
and safety precautions to ensure proper equipment
operation and to avoid bodily injury. Read and follow the
Safety Precautions and Instructions section. Keep this
manual with the equipment for future reference.
The equipment service requirements are very important
to safe and efficient operation. Inspect the parts often
and perform required service at the prescribed intervals.
Obtain service from a Lennox dealer to keep equipment
in top condition.
RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE
Shipping and Packing List
1 -- Generator Set
Check equipment for shipping damage. If you find any
damage, immediately contact the last carrier.
506088-01
OPERATION
MANUAL
RGEN12, RGEN17/18
RESIDENTIAL GENERATOR SET
XP-6515 4/09a
Table of Contents
Product Identification Information 2...............
Safety Precautions and Instructions 3.............
Introduction 7...................................
Section 1 Features 9.............................
1.1 Specifications 9.............................
1.2 Generator 9.................................
1.3 Engine 9...................................
1.4 Controller 9.................................
1.5 Generator Set Components 10.................
Section 2 Operation 12............................
2.1 Prestart Checklist 12..........................
2.2 Exercising Generator Set 12...................
2.3 Controls and Indicators 12.....................
2.4 Controller Power 13...........................
2.5 Generator Set Operation 14....................
2.6 Faults 14....................................
2.7 Battery Charger 17...........................
Section 3 Scheduled Maintenance, RGEN12 18......
3.1 Routine Maintenance 18.......................
3.2 Service Schedule, RGEN12 19.................
3.3 Lubrication System 20.........................
3.4 Spark Plugs 21...............................
3.5 Air Cleaner Element and Precleaner 21..........
3.6 Cooling System 22............................
3.7 Exhaust System 23...........................
3.8 Battery 23...................................
3.9 Battery Charger 24...........................
3.10 Circuit Protection 24..........................
3.11 Storage Procedure 25.........................
Section 4 Scheduled Maintenance, RGEN17/18 26...
4.1 Routine Maintenance 26.......................
4.2 Service Schedule, RGEN17/18 27..............
4.3 Lubrication System 28.........................
4.4 Spark Plugs 29...............................
4.5 Air Cleaner Service 30........................
4.6 Cooling System 30............................
4.7 Exhaust System 31...........................
4.8 Battery 31...................................
4.9 Battery Charger 32...........................
4.10 Circuit Protection 32..........................
4.11 Storage Procedure 33.........................
Section 5 Troubleshooting 34......................
5.1 Introduction 34...............................
5.2 Controller Troubleshooting 34..................
5.3 Generator Set Troubleshooting 35..............
5.4 Battery Charger Troubleshooting 36.............
To Next Page
Need help?
General
