2 Update LZ100 / LZV100 and LH100 to Version 3.6
1 New and changed features in version 3.6
Here is an overview of the new or changed features:
• Fast change between up to 12 freely selectable locomotive
addresses with the 'Esc' key.
• Functions F0 to F28 can now be switched.
• Functions F1 to F28 can be set to temporary or continuous
operation. This setting can be made individually for each
locomotive address. Ex-works, functions are set to continuous
operation.
• You can set which function information is to be stored in the
command station even when it is turned off. Ex-works,
functions F0 to F8 are stored.
• Function information stored in the command station is
transmitted cyclically via the track.
• The storage and cyclic transmission of information for
functions F5 to F28 can be activated and deactivated (only
LH100).
• Programming on the programming track from CV1 to CV1024.
• Programming in operational mode (PoM) from CV1 to
CV1024.
• Simple increasing and decreasing of CV values during
programming: Ideal, for example, for setting the maximum
speed of a locomotive (only LH100).
• Simple change to the next or previous CV during
programming (only LH100).
• Reading of CVs via PoM with the RailCom address display
LRC120.
To Next Page
Loading...
Need help?
General
