3
L
4. Erection
The devices must erected and cooled according to the regulations of the
corresponding documentation.
The drive controllers must be protected from inappropriate loads. Particularly
during transport and handling, components must not be bent and/or insulation
distances must not be modified. Touching of electronic components and
contacts must be avoided.
Drive controllers contain electrostatically sensitive components which can
easily be damaged by inappropriate handling. Electrical components must not
be damaged or destroyed mechanically (health risks are possible!).
5. Electrical connection
When working on live drive controllers the valid national regulations for the
prevention of accidents (e.g. VBG 4) must be observed.
The electrical installation must be carried out according to the appropriate
regulations (e.g. cable cross-sections, fuses, PE connection). More detained
information is included in the documentation.
Notes concerning the installation in compliance with EMC - like screening,
grounding, arrangement of filters and laying of cables - are included in the
documentation of the drive controllers. These notes must also be observed in
all cases for drive controllers with the CE mark. The compliance with the
required limit values demanded by the EMC legislation is the responsibility of
the manufacturer of the system or machine.
6. Operation
Systems where drive controllers are installed must be equipped, if necessary,
with additional monitoring and protective devices according to the valid safety
regulations, e.g. law on technical tools, regulations for the prevention of
accidents, etc. Modifications of the drive controllers and the operating software
are prohibited.
After disconnecting the drive controllers from the supply voltage live parts of the
controller and power connections must not be touched immediately because of
possibly charged capacitors. For this, observe the corresponding labels on the
drive controllers.
During operation, all covers and doors must be closed.
7. Maintenance and servicing
The manufacturer´s documentation must be observed.
This safety information must be preserved!
The product specific safety and application notes in these operating
instructions must also be observed!
To Next Page
Loading...
Need help?
General
