Lenze 8200 vector Mounting Instructions

8
Fault detection and elimination
Fault messages
EDK82EV113 DE/EN/FR 8.1
L
152
LED’s at the drive controller (status display)
LED −36− Operating status
red  green 
off on Controller enabled
on on Mains switched on and automatic start inhibited
off slowly blinking Controller inhibited
off fast blinking Motor parameter identification
fast blinking off Undervoltage switch−off
slowly blinking off Fault active, check under C0161
OFF
20 28
X3
880Hr
01 61
000
1
abcde
j g fkih PS 

mno
p
qr
Hi
Hz
%sh
rpm
°C
Ω
m
AV
Lo
3
1
4
5
2
6
ON
z
y
wx
v
t
u
s
88888
8888
888
8
a bcde
j gfkih PS 
 mno
p
qr
Hi
Hz
%sh
rpm
°C
Ω
m
AV
Lo
82vec355
Reset the drive controller in this way if a fault occurs (TRIP reset):
1. Plug the keypad onto the AIF interface during operation.
2. Read and take down fault message on the keypad display.
3. Inhibit controller.
4. Disconnect controller from the mains.
5. Carry out a fault analysis and eliminate the faults.
6. Restart the controller.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Lenze 8200 vector Specifications

General

Category	DC Drives
Series	8200 vector
Enclosure Rating	IP20
Control Method	Vector control
Communication	CANopen, DeviceNet, Profibus
Protection Features	Overcurrent, overvoltage, undervoltage, overtemperature, short circuit
Humidity	< 95 % non-condensing
Operating Temperature	0 to +45 °C (derating above 40°C)