Lexmark™ W840
Quick Tips
Loading paper or specialty
media
Loading the 500-sheet tray
1 Pull out the tray.
2 Squeeze the side guide tab, and slide the guide
to outside of the tray.
3 Squeeze the front guide tab, and then slide the
guide to the correct position for the paper you
are loading.
4 Flex the sheets back and forth to loosen them,
then fan them. Do not fold or crease the print
media. Straighten the edges on a level surface.
5 Load print media in the tray with the print side
up.
6 Squeeze the side guide tab, and slide the guide
until it lightly rests against the edge of the
media.
7 Insert the tray.
Loading the multipurpose feeder
1 Lower the multipurpose feeder.
2 Pull the tray extension out.
Note: Do not place objects on the
multipurpose feeder. Also, avoid
pressing down or applying
excessive force on it.
3 Slide the width guides to the outside of the
feeder.
4 Flex the sheets or envelopes back and forth to
loosen them, then fan them. Do not fold or
crease the print media. Straighten the edges on
a level surface.
5 Load the media in the feeder.
Note: Make sure the print media is below
the max fill line. Overloading may
cause jams.
To Next Page
Need help?
General
Weight and Dimensions
