Verwendung dieses Produkts in der Schweiz
Für dieses Produkt muss ein schweizerischer Billing Tone Filter zur Zählzeichenübertragung (Lexmark Teilenummer
14B5109) für jede Leitung installiert werden, über die in der Schweiz Zeitsteuertakte übertragen werden. Die
Verwendung des Lexmark Filters ist obligatorisch, da in allen analogen Telefonleitungen in der Schweiz
Zeitsteuertakte vorhanden sind.
Uso del prodotto in Svizzera
Questo prodotto richiede un filtro toni Billing svizzero, (codice Lexmark 14B5109), da installare su tutte le linee che
ricevono impulsi remoti in Svizzera. È necessario utilizzare il filtro Lexmark poiché gli impulsi remoti sono presenti
su tutte le linee analogiche in Svizzera.
Power consumption
Product power consumption
The following table documents the power consumption characteristics of the product.
Note: Some modes may not apply to your product.
Mode Description Power consumption (Watts)
Printing The product is generating hard-copy output from electronic
inputs.
14
Copying The product is generating hard-copy output from hard-copy
original documents.
15
Scanning The product is scanning hard-copy documents. 8
Ready The product is waiting for a print job. 6
Power Saver The product is in energy-saving mode. not applicable
High Off The product is plugged into a wall outlet, but the power switch
is turned off.
not applicable
Low Off (<1 W Off) The product is plugged into a wall outlet, the power switch is
turned off, and the product is in the lowest possible power
consumption mode.
not applicable
Off The product is plugged into a wall outlet, but the power switch
is turned off.
5
The power consumption levels listed in the previous table represent time-averaged measurements. Instantaneous
power draws may be substantially higher than the average.
Values are subject to change. See www.lexmark.com for current values.
Total energy usage
It is sometimes helpful to calculate the total product energy usage. Since power consumption claims are provided
in power units of Watts, the power consumption should be multiplied by the time the product spends in each mode
in order to calculate energy usage. The total product energy usage is the sum of each mode's energy usage.
Notices
79
To Next Page
Loading...
Need help?
General
