2-2.
Reconnect the another duct [11 in (28cm)] to
the blower housing, and attach the duct to the
base. (Duct is a SVC part)
2-1.
Detach and remove a knockout at the botton,
left or right side as desired. (Right Side Vent not
available on Gas dryer)
①①
,
②②
,
③③
the order of work.
3-1.
Pre-assemble 4" elbow with 4" duct.
Wrap duct tape around joint.
3-2.
Insert the elbow duct assembly through the side
opening and connect the elbow to the internal
duct.
When you disassemble and install ventilation, be
sure to take gloves and careful exhaust edge.
Failure to do so can cause serious injury.
To Next Page
Loading...
Need help?
General
