ENGLISH
38
SoftAP
• SoftAP is similar to Access Point. When you enable this function, TV acts as an Access Point.
• Regardless of the Instant On mode, the SoftAP setting stays unchanged after power o/on. (Depending on model)
Use Default
• If you want to use default password(this password was generated randomly), you must select ‘Enable’ in this item.
Security Key
• If you want to change default password, you need to change ‘Use Default’ value into ‘Disable’.
Wi-Fi Signal Strength
• You can control wireless signal strength on SoftAP. This is controlled by 5 step. If you select ‘Not Used’, wireless signal strength will be set to Max
value.
Wi-Fi Channel
• You can control wireless channel on SoftAP mode. This is controlled from 1 to 11 channel. If you select ‘Auto’, wireless channel of SoftAP will be
set to random channel.
Mode
• You can select NAT(Network address translation) mode and BRIDGE mode for Soft AP.
Security Type
• You can select ‘WPA2-PSK’, ‘WPA2-Enterprise’ and ‘Open’ if you selected ‘BRIDGE’ mode.
Radius Server IP, Radius Server Port, Radius Server Key
• You should enter Radius Server information if you selected ‘WPA2-Enterprise’.
Beacon
(Depending on model)
• This option enables BLE Beacon, one of Bluetooth 4.0's features.
• Beacon Mode (On/O Toggle): enables the Beacon feature.
• The iBeacon/Eddystone Type Beacon features are supported.
iBeacon
• Beacon UUID (hex): Set the UUID.
1 Field1: 4byte hex value (8 digits)
2 Field2: 2byte hex value (4 digits)
3 Field3: 2byte hex value (4 digits)
4 Field4: 2byte hex value (4 digits)
5 Field5: 6byte hex value (12 digits)
• Major (0–65535): Sets the Major value.
• Minor (0–65535): Sets the Minor value.
To Next Page
Loading...
Need help?
General
