29
Installation
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
packing within the hose can adhere completely to
the tap.
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then
tighten it by screwing it to the right.
Check water leakage.
After connecting the hose, open the tap to check
for any water leakage.
• Connect the water supply hose to inlet valve of
the washing machine, and then lock it by turning
the hose connecting part.
• Check to see if there is a rubber seal inside the
connector.
Screw Type
Water Supply Hose
Rubber Packing
Hose connector
Rubber seal
Water
tap
Connecting Water Supply Hose to the machine
1
2
3
To Next Page
Loading...
Need help?
General
