INSTALLATION INSTRUCTIONS
6
¡ÆInstallation clearances
The location must be large enough to fully open
the washer door.
¡ÆWasher dimensions
• Most installations require a minimum 4 in.
(10 cm) clearance behind the washer.
¡ÆMinimum installation spacing for
recessed area installation.
The following dimensions shown are for the minimum
spacing allowed.
Additional spacing should be considered for
installation and servicing.
• Additional clearances might be required for wall,
door and floor moldings.
• Additional spacing of 1 in. (2.5 cm) on all sides of
the washer is recommended to reduce noise
transfer.
Companion appliance spacing should also be
considered.
¡ÆLevel floor
Allowable slope under entire washer is 1°.
¡ÆPower outlet
Must be within 60 in. (1.5 m) of either side of the
washer. Do not overload the outlet with more
than one appliance.
[Front view]
[Side view]