7
Product Overview
Linksys X2000/X3000
Back
DSL—Connects to the ADSL line.
Cable—To use the modem router as only a router, use a
network cable to connect this port to a separate modem’s
LAN/Ethernet port.
Ethernet—Using Ethernet cables (also called network
cables), these Ethernet ports connect the modem router
to computers and other Ethernet network devices on your
wired network.
USB—For network-attached storage, connect an external
USB drive to this port.
Power—The Power port connects to the included power
adapter.
Power button—Press | (on) to turn on the modem router.
(Button not available on North American models.)
Bottom
Reset—This button allows you to reset the router to
its factory defaults. Press and hold the Reset button for
approximately five seconds.
Wall-mounting placement
The router has two wall-mount slots on its bottom panel. The distance between
the slots is 175.56 mm. Two screws are needed to mount the router.
Suggested Mounting Hardware
2.5-3.0 mm
4-5 mm 1-1.5 mm
NOTE
Cisco is not responsible for damages incurred by unsecured wall-
mounting hardware.
Follow these instructions:
1.
Determine where you want to mount the router. Make sure that the wall
you use is smooth, flat, dry, and sturdy. Also make sure the location is
within reach of an electrical outlet.
2. Drill two holes into the wall. Make sure the holes are 175 mm apart.
3. Insert a screw into each hole and leave 3 mm of its head exposed.
4. Position the router so the wall-mount slots line up with the two screws.
5. Place the wall-mount slots over the screws and slide the router down
until the screws fit snugly into the wall-mount slots.
175 mm
Wall-mounting template
Print this page at 100% size.
Cut along the dotted line, and place on the wall to drill precise spacing.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
