Lippert Components 13398-C User Manual

Manual Override - C1 & C2 versions
1. Electronic Manual Override (available on board revision C1 and newer)
Locate the circuit board
Press the “mode button” six times quickly, press a 7
th
time and hold for approximately
5 seconds.
The red and green LED lights will begin to ash, conrming the override mode.
Release mode button.
Back inside coach; use the normal slide control switch to retract the room.
A video demonstrating this technique can be found on the internet.
Follow this link: http://www.youtube.com/watch?v=ymt1Uesf0Pc
2. Disengage motors, manually retract room and travel lock.
Repeat this process for both sides of slide room.
Push or pull room back in to opening, keep both sides relatively even.
The room must be travel locked to keep room in place for road travel.
A video demonstrating this technique can be found on the internet.
Follow this link http://www.youtube.com/watch?v=ymt1Uesf0Pc
Mode Button
Motor Retention Screw
1/2”
Pull the motor up until
disengaged, about ½”
Bend back wipe seal and
visually locate motor
Locate and remove motor retention screw
located near top of each vertical column.

Lippert Components 13398-C Specifications

General

Brand	Lippert Components
Model	13398-C
Category	Controller
Language	English