Rev: 09.11.2018 Page 2 CCD-0002105
As a supplier of components to the RV industry, safety, education and customer satisfaction are our primary concerns. Should you
have any questions, please do not hesitate to contact us at (574) 537-8900 or by email at customerservice@lci1.com. Self-help tips,
technical documents, product videos and a training class schedule are available at lci1.com or by downloading the MyLCI app.
AUTO-ELECTRIC LEVELING SYSTEM
STABILIZER INSTRUCTIONS
QR-063
LEVELING AND STABILIZATION
7. Push "FRONT" button to engage fifth wheel latch.
8. Connect any wires, chains or sway control that may be equipped between the tow vehicle and the fifth
wheel.
9. Push the DOWN ARROW to display "AUTO RETRACT ALL."
10. Push "ENTER." Front jacks will automatically retract and then stop.
11. Raise inner drop leg and set the pin.
12. Double check that fifth wheel latch is secure and that all jacks are retracted.
13. Push the "ON/OFF" button on touchpad to turn system off.
14. Turn main power off.
NOTE: Main power should be off during travel.
15. Ready to tow.
Truck Hauler Operation (Manual Only)
NOTE: Loosen all stabilizer "T" handles.
1. Push the "ON/OFF" button on touchpad to turn system on. Green LED will illuminate.
2. If required, push "FRONT" button to extend front jacks to gain height.
3. Back tow vehicle to align fifth wheel hitch.
4. To retract jacks:
A. Push "RETRACT" button. Orange LED will illuminate.
B. Push the "FRONT" button to retract jacks and hook up the vehicle. Once fifth wheel is coupled and
latch is secure, push "FRONT" button and hold until jacks are fully retracted.
C. Push "ON/OFF" button to turn system off. Green LED goes out.
D. Double check fifth wheel latch is secure and that all jacks are retracted.
5. Push the "ON/OFF" button on touchpad to turn system off.
6. Ready to tow.
To Previous Page
Loading...
Need help?
General
