Rev: 02.24.20 Page 2 CCD-0001445
Introduction
The Tire Linc® tire pressure monitoring system is a wireless system that automatically monitors tire pressure
and temperature. If any abnormalities are detected, the system will transmit signals from the tire valve
sensors to the wireless receiver. Power is transmitted to the Tire Linc® via a 12V Power Connector that plugs
into a constant 12V power source.
Installation
Valve Stem Assemblies
Tire Linc Repeater
1. Install the repeater (Fig. 4) within 2' of single axle, centered between dual axle, OR within 2' of middle
axle on a triple axle (Fig. 5A).
2. Connect repeater to a constant 12-volt power supply.
Front of Coach
Fig. 1 Fig. 2
Fig. 3
Fig. 4
Fig. 5
A
Repeater
1. Lift and support the trailer per manufacturer’s requirements.
Lift unit by the frame and never the axle or suspension. Do not go under unit unless it is properly
supported by jack stands. Unsupported units can fall causing death or serious injury.
2. Remove the wheel. Relieve the air pressure in the tire and remove it from the rim.
3. Remove the existing valve stem from the rim (Fig. 1).
4. Clean valve stem hole in rim of any corrosion and debris.
5. Insert the Tire Linc valve stem assembly into each rim to be installed on the trailer (Fig. 2).
NOTE: Do not install a Tire Linc valve stem assembly into the spare tire.
6. Secure theTire Linc valve stem assembly into the rim with the plastic washer (Fig. 3A) and nut (Fig. 3B).
Tighten the nut to 40-45 in-lbs.
7. Remount the tires to the rims and inflate to the PSI recommended by the manufacturer.
Valve
Stem
Assembly
A
B
Front
Axle
To Next Page
Loading...
Need help?
General
