®
English Espa ol Fran ais Portugu s
5
Battery Life
The surface on which you use the mouse can significantly affect battery life. Lighter surfaces extend
battery life, darker ones shorten it. Bright, matte surfaces (not glossy ones) are recommended.
6
Get More Information!
A User s Guide, which has valuable information about your product (e.g., customer support numbers) is on the Logitech
¤
software CD and was copied to your hard drive. To find the User s Guide, do the following:
For PCs:
Go to the Taskbar, then select Start, Programs, Logitech
¤
, MouseWare
¤
, then User s Guide.
For the Macintosh
¤
:
On the desktop, find the MouseWare
¤
folder, then open the folder by double-clicking it. Find the icon
for the User s Guide, then double-click the icon to open the document.
7
Troubleshooting
The Mouse Does Not Work after Installation or Is Not Detected
¥ Make sure you have connected the receiver correctly. The receiver cable goes into the computer s USB port or PS/2 mouse
port. For optimal performance, place the receiver at least 8 inches or 20 centimeters aw ay from other electrical devices,
such as the computer, the computer monitor, or external storage drives.
¥ For PCs, make sure the PS/2 mouse port has the proper configuration. Refer to your computer documentation for the
correct port configuration. Yo u may also have other syste m d evices that conflict with the mouse. Check the IRQ/address
settings of these devices for conflicts, and change the settings as req uired.
¥Establish communication between the receiver and the mouse. Press the Connect button on the receiver, then press the
Connect button under the mouse.
¥ M ak e sure you have installed the batteries correctly. If you are working on a metallic surface, try turning the receiver on
its side for better reception.
¥Try unplugging then reconnecting the receiver cable to the computer.
8
International Standards and Safety
This mouse has no serviceable parts included. User-observable light is 15
microw atts in normal operation. This mouse is rated as a commercial product
for operation at 32
o
F (0
o
C) to 104
o
F (40
o
C).
This product has been tested to c omply with International Standard IEC 825-1:
1993. The standard requires the following statement:
CAUTION:
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation exposure.
Class 1 LED Product
To Next Page
Loading...
Need help?
General
