C200/SRM350
Bracket Kit Installation Instructions
This Bracket Kit allows the C200 and SRM350 loudspeakers to be own in an overhead rigging system. The kit contains
all the necessary hardware to suspend one loudspeaker vertically. You will need two Bracket Kits to suspend a loudspeak-
er horizontally.
WARNING: DO NOT USE THIS BRACKET KIT ON ANY LOUDSPEAKER OTHER THAN THE C200 AND SRM350.
Suspending anything, especially overhead of people, should be done with extreme caution. Always engage the services of
a certied professional who is qualied to determine the requirements for, and to implement, overhead rigging. Only per-
sons with the knowledge of proper hardware and safe rigging techniques should attempt to suspend loudspeaker systems
overhead. Failure to follow these precautions may result in equipment damage, injury, or death.
Tools Required:
One Phillips screwdriver
One 4 mm Allen head wrench
C200 and SRM350 Bracket Kit (Part No. 0016404)
Parts List
Item Part No. Qty Description
A 0015701 1 Bracket, Hanging SRM350
B 0016416 4 Screw, M5 x 12mm, Lg Blk
C 0016417 4 Washer, Split Lock, M5 Blk
D 0010024 4 Washer, Flat, M5 Blk
E 0015629 2 Eyebolt, M10
F 105056 2 Washer, Flat, M10 Blk
G 105058 2 Washer, Split Lock, M10 Blk
H 0016429 2 Nut, Hex, M10
0016401 1 Instruction Sheet (this sheet, not shown)
Suspending the loudspeaker vertically:
1. Remove handle by unfastening the 4 at head
screws from the top of the loudspeaker. Retain
the handle and screws for possible future
installation.
2. Position the Bracket (A) onto the top of the
loudspeaker.
3. Insert the 4 Screws (B), Lock Washers (C)
and Flat Washers (D) thru the outer mounting
holes of the Bracket, into the threaded inserts
in the loudspeaker and tighten. Use a 4 mm
Allen head wrench.
To Next Page
Need help?
General