BODY AIRBAG
SCORPIO
119
CHECK THE DAB LINES FOR OPEN
CIRCUIT
SRSI3
Turn the ignition key to OFF position.
Remove the Airbag simulator from DAB harness connector.
Disconnect Airbag Module connector
Measure the resistance between:
(+) Red Probe of Multimeter
DAB connector, harness side
(-) Black Probe of Multimeter
DAB connector, harness side
Is the resistance less than 1.5 ohms?
An intermittent fault may be present in the wiring
harness. Visually check for chaffed wires or other
physical damage to the harness. If no fault is found
in the circuit, suspect the following component(s):
a) Clockspring connector
b) DAB connector
c) Airbag module connector
d) Clockspring assembly
e) DAB assembly
f) Airbag module.
No
GO to SRSI4
To Next Page
Loading...
Need help?
General
