Makita 4327 User Manual

10 ENGLISH
1
Steel base type
1. Rip fence (Guide rule)
1
Aluminum base type
1. Rip fence (Guide rule)
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting
radius, and tighten the bolt to secure it in place.
Then move the base all the way forward.
NOTE:
• Always use blades No. B-17, B-18, B-26 or
B-27 when cutting circles or arcs. (For models
4326/4327/4328/4329)
• Always use Makita type blades No.6, No.7,
No.16, No.17, when cutting circles or arcs. (For
models 4326M/4327M)
Anti-splintering device for steel
base (optional accessory)
1
2
►1. Anti-splintering device 2. Protrusions
For splinter-free cuts, the anti-splintering device can
be used. To install the anti-splintering device, move the
base all the way forward and insert it between the two
protrusions of the base.
NOTE:
• The anti-splintering device cannot be used when
making bevel cuts.
Anti-splintering device for aluminum
base (Optional accessory)
1
2
►1. Anti-splintering device 2. Aluminum base
For splinter-free cuts, the anti-splintering device can
be used. To install the anti-splintering device, move the
toolbaseallthewayforwardandtitfromtheback
of tool base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
• The anti-splintering device cannot be used when
making bevel cuts.

Makita 4327 Specifications

General

Stroke height	18 mm
No-load stroke rate	3100 spm
Input power	450 W
Power source	AC
Cutting depth in wood	65 mm
Product color	Black, Blue
Bevel adjustment	Yes
Bevel capacity (max)	45 °

Weight and Dimensions

Depth	217 mm
Width	77 mm
Height	197 mm
Weight	1800 g