Makita CW002G User Manual

ENGLISH10
4. Selecting the control temperature
Press the temperature setting button to select the control
temperature. Refer the chapter "SPECIFICATIONS" for
the selectable control temperature.
The appliance starts cooling / heating 5 seconds after
without any operation, then the control temperature stop
ashingandthetemperaturedisplayshowsthecurrent
temperature.
The appliance stops cooling / heating when the current
temperature reaches the control temperature.
Tips for e󰀩cient cooling / heating
• Opening the upper cover for long periods can
causesignicantincrease/decreaseofthe
temperature in the chamber.
• Regularly clean surfaces that can come in contact
with food and accessible drainage systems.
• Storerawmeatandshinsuitablecontainersin
the chamber, so that it is not in contact with or drip
onto other food.
• If the chamber is left empty for long periods:
 - Switcho󰀨theappliance.
- Defrost the chamber.
- Clean and dry the chamber.
- Leave the upper cover open to prevent mould
developing within the chamber.
FUNCTION
Indicating the remaining battery
capacity
The battery indicator shows the remaining battery
capacity. The remaining battery capacity is shown as
the following table.
Battery indicator status Remaining
capacity
Lighted O󰀨
50 % to 100 %
20 % to 50 %
0 % to 20 %
(Blinking)
Charge the
battery.
(Only for battery cartridges with the
indicator)
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for a few seconds.
►Fig.3
1. Indicator lamps 2. Check button
Indicator lamps Remaining
capacity
Lighted O󰀨 Blinking
75 % to 100 %
50 % to 75 %
25 % to 50 %
0 % to 25 %
Charge the
battery.
The battery
may have
malfunctioned.
NOTE: Depending on the conditions of use and the
ambienttemperature,theindicationmaydi󰀨erslightly
from the actual capacity.
NOTE:Therst(farleft)indicatorlampwillblinkwhen
the battery protection system works.
Appliance / battery protection
system
The appliance is equipped with the protection
system.Thissystemautomaticallycutso󰀨powerto
extend appliance and battery life. The appliance will
automatically stop during operation if the appliance or
battery is placed under one of the following conditions.
•
Battery overdischarge protection
When the battery capacity becomes low, the
appliance stops automatically. The battery
indicator prompts that the battery should be
charged. Remove the batteries from the appliance
and charge the batteries.
• Overcurrent protection
When the appliance / battery is operated in a
manner that causes it to draw an abnormally high
current, the appliance automatically stops. In this
situation, stop the application that caused the
appliance to become overloaded. Then turn the
appliance on to restart.
• Low-voltage protection
When the car input voltage is lower than the
ratedvoltage,thisprotectionsystemturnso󰀨the
appliance and the temperature display shows "F3"
with beep sound.

Makita CW002G Specifications

General

Brand	Makita
Model	CW002G
Category	Accessories
Language	English