Makita DUR369AZ User Manual

20 ENGLISH
2. Adjustthehangerpositionasshowninthegure
and then tighten the hex socket head bolt.
1
2
3
750 mm
750 mm
100-300 mm
1 The hanger position from the ground
2 The cutting tool position from the ground
3 The horizontal distance between the hanger
and the unguarded part of the cutting tool
Correct handling of the tool
WARNING: Always position the tool on your
right-hand side. Correct positioning of the tool allows
for maximum control and will reduce the risk of seri-
ouspersonalinjurycausedbykickback.
WARNING: Be extremely careful to maintain
control of the tool at all times. Do not allow the
tool to be deected toward you or anyone in the
work vicinity. Failure to keep control of the tool
couldresultinseriousinjurytothebystanderandthe
operator.
WARNING: To avoid accident, leave more
than 15m (50 ft) distance between operators when
two or more operators work in one area. Also,
arrange a person to observe the distance between
operators. If someone or an animal enters the
working area, immediately stop the operation.
CAUTION: If the cutting tool accidentally
impacts a rock or hard object during operation,
stop the tool and inspect for any damage. If the
cutting tool is damaged, replace it immediately.
Use of a damaged cutting tool may result in serious
personalinjury.
CAUTION: Remove the blade cover from the
cutter blade when cutting the grass.
Correct positioning and handling allow optimum control
andreducetheriskofinjurycausedbykickback.
DUR369A
DUR369L
When using a nylon cutting head (bump & feed
type)
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
1
►1.Moste󰀨ectivecuttingarea
NOTICE: The bump feed will not operate prop-
erly if the nylon cutting head is not rotating.
NOTE: If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures in the section for the
maintenance.

Makita DUR369AZ Specifications

General

Type	2-in-1 Brush cutter & String trimmer
Cordless	Yes
Head type	Blade & nylon line
Handle type	U-type handle
Product color	Green
Rotational speed	7000 RPM
Cutting diameter (max)	430 mm
Power source	Battery
Battery voltage	18 V
Battery included	No

Weight and Dimensions

Length	1905 mm
Weight	5900 g