Models HM0871C and HM0870C are 5kg-class demolition hammers
adapted for SDS-MAX bits, and developed from HM0860C, featuring:
Same high work efficiency as HM0860C
Higher durability achieved by using ball bearing for crank section
AVT* for reduced vibration during chipping (HM0871C only)
Suppression of motor speed during no-load for reduced vibration
when idling
Listed below are the specification differences between the two models.
Dimensions: mm (")
Width (W)
Height (H)
Length (L)
Model No.
HM0870CHM0871C
466 (18-3/8) 449 (17-3/4)
116 (4-9/16) 109 (4-1/4)
230 (9)
L
H
W
Specification
Standard equipment
Optional accessories
Note: The standard equipment for the tool shown above may vary by country.
Continuous Rating (W)
Voltage (V) Cycle (Hz)
Input Output
Max. Output (W)
110
120
220
230
240
12
10
5.8
5.8
5.8
50/60
50/60
50/60
50/60
50/60
1,100
---
1,100
1,100
1,100
450
450
500
500
500
1,200
1,200
1,200
1,200
1,200
Current (A)
Model No.
HM0870CHM0871C
Europe, Hong Kong, Korea: 4.0 (13.1);
Brazil: 2.0 (6.6); Other countries: 5.0 (16.4)
Double insulation
Power supply cord: m (ft)
Yes
5.6 (12.4) 5.1 (11.1)
5.8 (12.8) 5.3 (11.6)
Net weight*1: kg (lbs)
Net weight*2: kg (lbs)
Impacts per min: min-1= ipm
Shank diameter: mm (")
1,100 - 2,650
Electronic
control
Variable speed control by dial
Constant speed control
Soft start
Yes
Yes
Yes
Suppression of motor speed
during no-load
Yes No
Yes No
18 (11/16)
Shank type Adapted for SDS-MAX bits
*1 Weight according to EPTA-Procedure 01/2003, with bar-shaped Side handle.
*2 Weight according to EPTA-Procedure 01/2003, with D-shaped Side handle.
Bull points
Cold chisels
Scaling chisels
Scaling chisel (for Tile)
Grooving chisel
Clay spade
Bushing tool
Rammer
Shank (for Bushing tool and Rammer)
Grease vessel (containing 30g hammer grease)
Side handle (Bar-shaped/ D-shaped)
Safety goggles
Hammer service kit
Side handle (Bar- or D-shaped) ........... 1
Bit grease .............................................. 1
Plastic carrying case ........................ 1
Cleaning cloth .................................. 1
Vibration
absorption
AVT (Anti-Vibration Technology using
Active dynamic vibration absorber)
Vibration absorbing handle
Yes No
[The image above is HM0871C.]
Model No.
AVT*
Vibration absorbing handle
Yes No
HM0870CHM0871C
Suppression of motor speed during no-load
Models No.
Description
PRODUCT
T
ECHNICAL INFORMATION
CONCEPT AND MAIN APPLICATIONS
P 1/ 17
HM0871C, HM0870C
Demolition Hammers
*Anti-Vibration Technology using Active dynamic vibration absorber
To Next Page
Need help?
General
Weight and Dimensions
