15
• Make sure all the connections are routed away from any
potentially pinching or slicing other metallic parts.
• Slowly slide the radio into the sleeve until it locks in place.
• The rubber ring will act as a seal against the DIN Sleeve.
3.2. Microphone
Connect the microphone to the microphone connector (5) and
screw the coupling nut hand-tight.
4. Disassembly
If you plan to remove the radio from DIN Sleeve, you should do it
using the provided two removal keys as explained below:
• Fully insert both removal keys straight into the slot spaces
of the rubber ring on the left and the right edges of the
radio front panel.
• You cannot remove the radio if only one key is used.
• Press in fully and the radio will unlock from the sleeve
making withdrawal from the sleeve possible.
• Store the keys in a safe place for future use
• Now disconnect the DC and antenna connector (13 and
12).
To Next Page
Loading...
General