EasyManuals Logo
Home>Manitou>Forklifts>MC 40 Powershift

Manitou MC 40 Powershift User Manual

Manitou MC 40 Powershift
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #81 background imageLoading...
Page #81 background image
3 - 24
E - EVERY 800 HOURS SERVICE
Carry out the operations described previously as well as the following operations.
E1 - FUEL TANK
CLEAN
While carrying out these operations, do not smoke or work near a flame.
Place the lift truck on level ground with the I.C. engine stopped.
- Inspect the parts susceptible to leaks in the fuel circuit and in the tank.
- In the event of a leak, contact your dealer.
Never try to carry out a weld or any other operation by yourself, this could provoke
an explosion or a fire.
- Place a container under drain plug 1 (Fig. E1/1) and unscrew the plug.
- Remove cap 2 (Fig. E1/2).
- Let the fuel flow and clean with 10 litres of clean fuel by filler port 3 (Fig. E1/2).
- Refit and tighten drain plug 1 (Fig. E1/1) (Tightening torque 29 to 39 N.m).
- Fill the fuel tank with clean fuel (See chapter : LUBRICANTS AND FUEL in paragraph :
3 - MAINTENANCE) filtered through a strainer or a clean, lint-free cloth and refit the
filler plug 2 (Fig. E1/2).
- Open the I.C. engine bonnet.
- Disassemble the left side panel 4 (Fig. E1/3) (3 fastening screws).
- Re-prime the system by activating fuel feed pump 5 (Fig. E1/4).
- If necessary, bleed the system (See chapter : G1 - FUEL SYSTEM in paragraph : 3 -
MAINTENANCE).
- Reassemble the left side panel 4 (Fig. E1/3).
E2 - SAFETY DRY AIR FILTER CARTRIDGE
CHANGE
- For the disassembly and reassembly of the cartridge, see chapter : D3 - DRY AIR
FILTER CARTRIDGE in paragraph : 3 - MAINTENANCE.
- Gently remove the dry air filter safety cartridge 1 (Fig. E2), taking care to avoid spilling
the dust.
- Clean the gasket surface on the filter with a damp, clean lint-free cloth.
- Before mounting check the state of the new safety cartridge (See chapter : FILTERS
CARTRIDGES AND BELTS in paragraph : 3 - MAINTENANCE).
- Introduce the cartridge into the filter axis and push it in, pressing the edges and not the
middle.
NOTE : The periodicity for changing the safety cartridge is given for information only.
The safety cartridge must be changed for every two changes of the air filter
cartridge.
E1/1
E1/2
E1/4
E2
1
3
2
1
5
E1/3
4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Manitou MC 40 Powershift and is the answer not in the manual?

Manitou MC 40 Powershift Specifications

General IconGeneral
BrandManitou
ModelMC 40 Powershift
CategoryForklifts
LanguageEnglish

Related product manuals