To Next Page

To Previous Page

Part Number 80-1479-3 7/10 37

Step 7 Mix a solution of cleaner and warm water.

Depending upon the amount of mineral buildup, a

larger quantity of solution may be required. Use the

ratio in the table below to mix enough solution to

thoroughly clean all parts.

Step 8 Use 1/2 of the cleaner/water mixture to clean

all components. The cleaner solution will foam when it

contacts lime scale and mineral deposits; once the

foaming stops use a soft-bristle nylon brush, sponge

or cloth (NOT a wire brush) to carefully clean the parts.

Soak parts for 5 minutes (15 - 20 minutes for heavily

scaled parts). Rinse all components with clean water.

Step 9 While components are soaking, use 1/2 of the

cleaner/water solution to clean all foodzone surfaces

of the ice machine and bin (or dispenser). Use a nylon

brush or cloth to thoroughly clean the following ice

machine areas:

• Side walls

• Base (area above water trough)

• Evaporator plastic parts - including top, bottom,

and sides

• Bin or dispenser

Rinse all areas thoroughly with clean water.

Continued on next page …

Step 10 Mix a solution of sanitizer and warm water.

Step 11 Use 1/2 of the sanitizer/water solution to

sanitize all removed components. Use a spray bottle

to liberally apply the solution to all surfaces of the

removed parts or soak the removed parts in the

sanitizer/water solution. Do not rinse parts after

sanitizing.

Solution Type Water Mixed With

Cleaner 1 gal. (4 l)

16 oz (500 ml)

cleaner

Solution Type Water Mixed With

Sanitizer 6 gal. (23 l)

4 oz (120 ml)

sanitizer

Manitowoc SY0854A User Manual

Other manuals for Manitowoc SY0854A