safe • timeless • beautiful
Conservatory awnings − shade for large areas
markilux 8800 | pergola 110 / 210 | pavillon
markilux
20-04-2015 7060488 TK + QS
What to to do, if...
Page
1. … the cassette cover has to be removed?
2
2. … the tension on the cloth has to be released?
2
3. … the drive belt in the guide rail is twisted?
3
4.
… the drive belt has to be wound around the roller tube again?
− Application of the drive belt assembly tool
4
5. … the awning does not retract/extend or the motor limit switch is wrongly adjusted?
4
6. … the awning stops approx. 10 - 15 cm prior to retraction position?
4
7. … the projection profile stops before reaching the end stop in extension direction?
5
8. ... the awning has no tension on one side?
6
9. ... the awning has no tension in the middle position?
7
10. … the awning runs unevenly?
7
11. … the Velcro fastener / drive belt has been pulled out of the belt clamp in the projection prole?
7
12. … the awning cloth should be replaced?
8
13. … the projection profile cap (with carriage) should be replaced?
9
14. … the motor should be replaced?
10
15. … the drive belt needs to be replaced?
11
16. … the projection prole does not retract completely on one side?
12
17. … maintenance is required?
12
18. Motor overview
13
19. Brief instructions for "Becker" drive with electronic limit switch (standard motor without radio)
14
20. Important general guideline for this "What do I do, if, ...?" booklet
17
What to to do, if...
This booklet describes in simple words the necessary
assembly steps in case any problems occur.
Table of contents
markilux 8800
markilux pergola 110 / 210
markilux pavilion
The work described here may only be carried out by a trained
markilux specialist company.
To Next Page
Need help?
General
