Marshall Amplification 1987X User Manual

WARNING! IMPORTANT SAFETY INSTRUCTIONS
ENGLISH
WARNING:
Before going any further, make sure that
your amplier is compable with your
mains electricity supply (for 1959SLP
& 1987X only, please refer to MAINS
SELECTOR [Rear Panel Funcon #16]).
If you have any doubt, please seek
help from a qualied technician – your
Marshall dealer can help you in this
respect.
MAINS INPUT & FUSE:
The specic mains input voltage
rang that your amplier has been
manufactured for is indicated on
the rear panel of the amplier. Your
amplier is provided with a detachable
mains (power) lead, which should be
connected to the MAINS INPUT socket
on the rear panel of the amplier
(1959SLP & 1987X Rear Panel Funcon
#17, 1962 Bluesbreaker Rear Panel
Funcon #20, 2245 JTM45 Rear Panel
Funcon #17). The correct value and
type of mains fuse is specied on the
rear panel of the amplier.
NEVER aempt to bypass the fuse or t
one of the incorrect value or type.
TRANSPORTING YOUR EQUIPMENT:
Please ensure that your amplier is
switched o, unplugged from the mains
electricity supply and that all removable
cables have been disconnected from
your equipment before aempng to
move it.
IMPORTANT SET UP INFORMATION:
1. Before connecng a speaker
cabinet(s), make sure the OUTPUT
SELECTOR (1959SLP & 1987X
Rear Panel Funcon #15, 1962
Bluesbreaker Rear Panel Funcon
#18, 2245 JTM45 Rear Panel
Funcon #15) is set to the correct
impedance.
WARNING: Failure to select the correct
impedance may damage your amplier.
When connecng a speaker cabinet(s)
make sure that you use a proper speaker
cable. Never use a screened (shielded)
guitar cable for this purpose.
2. Ensure that the MAINS (power)
switch is set to the OFF posion
(Front Panel Funcon #1).
3. Connect the supplied mains (power)
lead into the MAINS INPUT rst
and then into the mains electricity
supply.
4. Ensure that the LOUDNESS or
VOLUME controls on the front
panel are set to zero (1959SLP &
1987X Front Panel Funcons #8 &
9, 1962 Bluesbreaker Front Panel
Funcons #10 & 11, 2245 JTM45
Front Panel Funcons #8 & 9).
5. Plug your guitar into an INPUT
jack socket (Front Panel Funcon:
1959SLP, 1987X & 2245 JTM45
Front Panel Funcons #10, 1962
Bluesbreaker Front Panel Funcons
#12).
6. Ensure that the STANDBY switch is
in the ‘standby’ posion (Front Panel
Funcon #2).
7. Turn the front panel MAINS switch
to the ON posion and wait for a
few minutes before going to point 8.
8. Engage the amplier by switching
STANDBY to the ON posion.
9. Turn the LOUDNESS or VOLUME
up to your preferred level and your
amplier is ready to play.

Marshall Amplification 1987X Specifications

General

Brand	Marshall Amplification
Model	1987X
Category	Amplifier
Language	English