Master WIND User Manual

All the products and the specific technicals contained in this document are subjects to variations without any warning.
MASTER declares that the device meets the principal requirement and the other regulations of the directive 1999/5/CE.
The declaration of conformity of the above products is available on the web site section «Conformity products».http://www.mastermotion.eu/it-IT/download,
6. Device Scheme
WIND rev.02 dated30.08.12
L
L
0
N
N
AN
C
C
P
P
7
Km/h
40
Km/h
-
+
WIND THRESHOLD
ADJUSTING TRIMMER
KEY RESET
LABEL IDENTIFICATION
PROTECTION
FUSE
L
0
N
AN
CP
-
+
common
motor
ground
contact
M
POWER
SUPPLY
POWER
SUPPLY
L
N
8. Connection scheme beetween WIND and grouping modules
Wind Sensor
mod. X15C
Manual control
Motor with mechanical limit switch
IN ORDER TO CHECK THAT CONNECTIONS HAVE BEEN DONE AS THE
SCHEME, TAKE THE AWNING IN INTERMEDIATE POSITION AND ROTATE
THE SENSOR BLADES SINCE WIND ALARM GET ON. THE AWNING MUST
MOVE UPWARD. IF THEAWNING MOVE DOWNWARD REVERSE THE WIRES
OPERATION OF MOTOR OR MOTORS.
IS POSSIBLE EXIT FROM WIND ALARM WITHOUT WAITING 8 MINUTES,
KEEP HOLD KEY«RESET» SINCE RED LED SWITCH OFF.
SYSTEM CHECK
required
L N C
L
N
terminal
WIND
terminal
X52
L N
CP
POWER
SUPPLY
L N C
L
N
terminal
WIND
terminal
X54
Connection scheme beetween WIND and grouping module X52 Connection scheme beetween WIND and grouping module X54
7. Electric Connection Scheme
WIND ALARM LED SIGNALLING

Master WIND Specifications

General

Brand	Master
Model	WIND
Category	Controller
Language	English