2021 OWNERS MANUAL / 352
Periodic cleaning is the best way to keep your boat looking like
new. Regular washing and waxing keep dirt and build-up from
deteriorating the finish. If you keep your boat in showroom-new
condition, then your personal satisfaction will be higher and the
resale value of your boat will be greater.
The boat is made of fiberglass-reinforced plastic resin material that
is easy to clean and care for. Several layers of resin material are
chemically bonded together to form the hull. The smooth outside
surface of the hull is a layer of gel coat resin. The gel coat is a solid
color that is only a few millimeters thick.
Beneath the gel coat surface is a series of layers of chemical resin,
fiberglass mat and woven roving. It is these layers that give the boat
its strength and maintain the hull shape. The boat bottom also uses
special coremat material for its strength-to-weight and superior
marine performance.
Even though MasterCraft has carefully crafted boats from
resilient materials, it is still the responsibility of the boat owner
to perform regular and routine cleaning maintenance to ensure
that the boat exterior, interior and components retain both their
appearance and strength.
HULL
When washing the boat, use a mild detergent, such as Dawn or Ivo-
ry dish soap, or similar commercially-produced detergent, and warm
water solution. DO NOT use abrasive cleaners, solvents, ammonia or
chlorine, as these will damage the gel coat surface.
Under extreme conditions, special cleaners may be used to remove
marine growth from the hull. (See an authorized MasterCraft service
department for further instructions.)
2021MCOwnerManualFINAL.indd 352 8/26/20 1:54 PM
To Next Page
Loading...
Need help?
General
