2021 OWNERS MANUAL / 354
should be thinned with a thinner like mineral spirits before use.
(70 percent oil-30 percent thinner.)
When oiling a platform, apply a coat of oil with a wet cloth, work into
the seams, end grain and edges. Allow the oil to set approximately
15 minutes and then wipe o the excess oil with a dry cloth. Do
not let the oil dry on the platform in the sun. Excess oil should be
removed with a dry cloth.
SeaDek Platforms
SeaDek should be handled only with clean hands. Oil, grease or dirt
may leave permanent imprints on the surface. Whenever possible,
keep the platform covered when the boat is not in use. It should be
stored dry. Refer to the SeaDek Pads section later in this chapter for
instructions on how to clean your SeaDek Platforms.
Fiberglass Swim Platform
The fiberglass swim platform requires the same kind of regular—
and gentle—cleaning that the rest of the boat needs. After cleaning
o any environmental debris, wash with mild soap and warm water.
Avoid the use of ArmorAll or similar types of rubber-shine products
as these will speed the decay of the rubber rather than protect it.
WINDSHIELD
In cleaning tempered glass windshields, the normal glass cleaners
(from spray bottles or aerosol cans) work best. While the glass is
very strong, it can be scratched if anything abrasive is used. Harsh
chemicals or solvents should be avoided because they may aect
the vinyl gaskets, anodized or powder-coated finish on the extrusions.
2021MCOwnerManualFINAL.indd 354 8/26/20 1:54 PM
To Next Page
Loading...
Need help?
General
