2021 OWNERS MANUAL / 272
4. Torque each bolt to 80- ft-lbs. As the bolts are tightened with
a torque wrench, the adjacent bolts will likely loosen due to the
additional clamp load. Run through the crisscross tightening
pattern several times until all bolts are torqued to 80 ft-lbs.
The vertical surf racks on the ZFT7 tower are not designed for
removal. If removal is necessary MasterCraft recommends taking
the boat to an authorized dealer for removal. Defects as a result
of removing, or attempting to remove or install surf racks are not
covered by warranty (dents, scratches, scus, etc.).
Surf Tow Points
Surf tow points are mounted on the inboard side of the ZFT7 and
ZFT4 towers near where the tower legs bend into the top of the tower
so that ropes do not interfere with board racks or boards.
Surf tows are intended for surfing only. MasterCraft highly discour-
ages towing any other sport from these mounts. Do not tow from all
3 tower tow points at once.
Since surf tow points are not vertical, a slack rope is more likely to
fall o. Double loop (if possible) rope around the tow point to reduce
the risk of a rope falling o the tow point.
Troubleshooting
Lights: If the lights do not work when the switch is turned ON, check
the main circuit breaker panel to determine whether the circuit has
tripped, and reset if necessary. If the circuit continues to trip or if the
circuit is on but the lights still do not work, take the boat to an autho-
rized MasterCraft dealer for attention.
Speakers: If the audio speakers on the tower do not work, verify
electrical circuits by checking the main circuit breaker panel. Reset
if it has tripped. If it still does not work, take the boat to an autho-
rized MasterCraft dealer for repair.
Board Racks: If boards will not sit securely in place, and it is de-
termined that the proper board for the proper rack is in use, do not
leave the board in the rack. Take the boat to an authorized Master-
Craft dealer to determine the underlying cause.
Front Tower Leg
Rear Tower Leg
Surf Rack
Mounting Bracket
1/8” Gap
2021MCOwnerManualFINAL.indd 272 8/26/20 1:53 PM
To Next Page
Loading...
Need help?
General
