269
/
2023 OWNER’S MANUAL
Operation
Lights: To activate forward-facing lights and speaker lights, use
the lighting tab on the touchscreen. To adjust speaker lights, use
the + and - buttons on the same screen. To activate the dome light,
push up on the light until it activates. (For more information on
lighting accessories, see the “Visual Assistance” chapter.)
Speakers: Tower speakers are controlled using the audio settings
found on the dash touchscreen. For more information, consult the
“Screen Operations” chapter of this manual.
Board racks: Board racks are operated using a black and red lever
system on the backside of the rack. To open the clamps, press
down on the red release button. The clamps will open in response.
To shut the clamps, push the lever/handle upwards. Once the
lever/handle has moved as far into its slot as it can go, you will
hear the red lock button click into place. Remove your finger from
the button.
Regardless of which board type you choose to store inside the
rack, it is very important to make sure the board is securely
clamped. This will prevent the board from coming loose when the
boat is in operation. Additionally, make sure that you are storing
the correct type of board inside the clamps. An improper fit will
leave the board too loose in the racks. Resulting loss, damage, or
injury is not the responsibility of the product manufacturer.
Troubleshooting
Lights: If one of the lighting accessories does not work when
the digital switch is flipped to the “On” position, check the
“Diagnostics” menu on the dash touchscreen. Reset the circuit
if necessary. If the circuit continues to trip, or if the circuit is
on but the lights still don’t work, take the boat to an authorized
MasterCraft dealer.
Speakers: If the speaker accessories do not work when the digital
switch is set to the “On” position, check the “Diagnostics” menu on
the dash touchscreen to find out whether the circuit has tripped.
Reset the circuit if necessary. If it still does not work, take the boat
to an authorized MasterCraft dealer for inspection.
Board Racks: If a board rack seems unsecured and you determine
that the proper board is in use, do not leave the board in the rack.
Take the boat to an authorized MasterCraft dealer.
If you choose to install secondary board racks, ask your dealer
about installing a tower stop-pin in the main knuckle behind the
access plates. A stop-pin can limit the tower’s downward travel,
preventing the secondary racks from colliding with the deck and
upholstery. Failure to install a protective stop-pin for secondary
board racks may result in property damage.
To Next Page
Loading...
Need help?
General
