3
WARNING!
There are several areas during the assembly process that special
attention must be paid. It is very important to follow the assembly
instructions correctly and to make sure all parts are rmly tightened. If
the assembly instructions are not followed correctly, the equipment could
have parts that are not tightened and will seem loose and may cause
irritating noises. To prevent damage to the equipment, the assembly
instructions must be reviewed and corrective actions should be taken.
PARTS INCLUDED:
F 1 Elliptical Frame
F 1 Console Mast
F 1 Console Mast Boot
F 2 Upper Dual Action Arms
F 2 Lower Dual Action Arms
F 2 Handlebar Caps
F 2 Pedals with Inserts
F 2 Transport Handles
F 1 Power Cord
F 1 Hardware Kit
Console sold separately
ASSEMBLY
Before proceeding, nd your elliptical’s serial number located on a barcode
sticker and enter it in the space provided below.
SERIAL NUMBER
MODEL NAME
F E30 F E50 MATRIX ELLIPTICAL
* Use the information above when calling for service.
SERIAL NUMBER LOCATION
UNPACKING
Unpack the equipment where you
will be using it. Place the carton
on a level at surface. Never open
box when it is on its side.
NEED HELP?
If you have questions or if there are any missing parts, contact Customer Tech
Support. Contact information is located on the information card.
IMPORTANT NOTES
During each assembly step, ensure that ALL nuts
and bolts are in place and partially threaded.
Several parts have been pre-lubricated to aid in assembly
and usage. Please do not wipe this off. If you have diculty,
a light application of lithium grease is recommended.
TOOLS INCLUDED:
F 5 mm Allen Wrench
F 6 mm Allen Wrench
F 13/17 mm Flat Wrench
F Phillips Screwdriver
ENGLISH
To Next Page
Loading...
Need help?
General
