MG-MR47 FRAME ASSEMBLY
1. Place lower base support and bases where the machine is to be used. Using (4) 3/8-16 x 1”
bolts and (4) 3/8” washers attach base support to bases and torque all bolts to 30 ft lbs.
2. Attached each upright to the base using (16) 3/8-16 x 1” bolts and (16) 3/8” washers.
Do not fully tighten bolts.
3. Weight storage: Using (4) 3/8-16 x 1” bolts and (4) 3/8” washers attach the bottom of the
weight storage to the bases. Do not fully tighten bolts.
4. Weight storage top: Using (8) 3/8-16 x 1” bolts and (8) 3/8” washers attach the top of the
weight storage to the uprights. Do not fully tighten bolts
5. Upright support: Using (16) 3/8-16 x 1” bolts and (16) 3/8” washers attach the upright
support to the top of the uprights. Do not fully tighten bolts.
6. Upright support, front: Using (8) 3/8-16 x 1” bolts and (8) 3/8” washers attach the front
upright support between the front (2) uprights. Do not fully tighten bolts.
7. Upright/Chin bar support: Using (8) 3/8-16 x 1” bolts and (8) 3/8” washers attach the
upright/chin bar supports between the rear (2) uprights. Do not fully tighten bolts.
8. Chin bar: Using (4) 3/8-16 x 1” bolts, (4) 3/8” washers, (4) 1/2-13 x 4 1/2” bolts, (8) 7/16”
washers and (4) 1/2-13 nuts attach the chin bar between the top upright supports. Do not
fully tighten bolts.
9. Tighten bolts: Starting with the bottom of the uprights and working up to the top of the
machine tighten all bolts to 30 ft lbs.
10. Spotter stands: Using (1) 1/2-13 x 7 1/2” bolt, (2) 1/2” machined washers and (1) 1/2-13
nut attach spotter stand to frame mount on bases.
Step 1
Step 2
Step 3
Step 4
To Next Page
Loading...
Need help?
General
