71
CHAPTER 10: TREADMILL SPECIFICATIONS AND ASSEMBLY GUIDE
10.5 PCTV BRACKET INSTALLATION INSTRUCTIONS - CONTINUED
18) Mount the TV to the bracket using 4 screws sent with the TV (Figure S).
19) Make sure that the tabs on the front plate are tucked behind the console faceplate to create a seamless look (Figure T).
20) Install the console back cover removed in Step 2 (Figure U). NOTE: Make sure that the coax, power, net, and controller wires are tucked
in the slot in the cover (created by removing the small Matrix logo cover) (Figure V).
21) Install the TV back cover onto the TV (Figure W).
22) Plug a working coax cable with a signal strength of 10 Hz to the port at the base of the treadmill (Figure X).
FIGURE S FIGURE T
FIGURE U FIGURE V
FIGURE W FIGURE X
To Next Page
Loading...
Need help?
General
