29
CHAPTER 7
CAUTION: Do not exceed five M’elodie
cabinets high to avoid tipping over the stack.
CAUTION: Avoid moving the M’elodie
stack in the front-to-back direction of the
loudspeakers (the long side); always move the stack
sideways to avoid tipping it over.
STOW
STOW
A
B
A
B
GROUND S TACK
FRONT LIN K
GROUND S TACK
REAR LIN K
MAXIMU M DOWN-TILT
MAXIMU M UP-TILT
B A
0º
B B
-5º
A B
-10º
FRONT
LINK
REAR
LINK
RESULT
ANGLE
-5º
0º
MG-M’E LODIE
B
A
STOW
Berkeley, CA
SEE MG-M’ELODIE ASSEMBLY GUIDE FOR ADDITIONAL LOAD
RATINGS AND RIGGING SAFETY INFORMATION.
DO NOT EXCEED
GRID TILT
CAUTION: DO NOT EXCEED LOAD RATING
PRECAUTION: NO EXCEDER LIMITE DE CARGA
ATTENTION: N'EXCEDEZ PAS L'ESTIMATION DE CHARGE
VORSICHT: UBERSTEIGEN SIE NICHT LAST BEWERTUNG
5:1 7:1
LOAD RATINGS
1550 lbs
702 kg
(25 M’elodie)
1116 lbs
506 kg
(18 M’elodie)
+/-60 DEG.
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
0
3
6
9
11
Figure 7.13. The M’elodie stack should only be moved sideways when being
transported on the MCF-M’elodie caster frame
The M’elodie GuideALinks allow multiple transport angles
with the MCF-M’elodie caster frame.
■ Use the 5 position on the M’elodie rear GuideALink to
get the first M’elodie with respect to the caster frame at
0 degrees. This setting is preferred when all M’elodies
are at 0 degrees.
■ Use the 0 position to downtilt the first M’elodie with
respect to the caster frame, to compensate if the rest of
the M’elodies in the stack have severe angles.
Figure 7.14. First M’elodie at 0 degrees (straight-up) with respect to the
MCF-M’elodie
Figure 7.15. First M’elodie at -5 degrees (downtilted) with respect to the
MCF-M’elodie
TIP: The MG-M’elodie can travel installed on
top of a M’elodie stack.
Use position 5
Use position 0
To Next Page
Loading...
Need help?
General
