To Next Page

To Previous Page

CleaningCharging Robot Vacuum

Please clean up the wires and sundries scattered on the ground and remove precious,

fragile and dangerous items that are easy to fall before cleaning.

15 16

During its ﬁrst cleaning job, it is recommended to follow the robot to ﬁnd some possible

problems. The robot can clean much more smoothly after that. If certain area do not

need to be cleaned, you can add No-Go Zones or Virtual Walls on the map via the app

to prevent the robot from entering the speciﬁed area.

Do not use your robot on wet surfaces or surfaces with standing water. Before using the product on

a rug with tasseled edges, please fold the rug edges under.

NOTE

Press and hold the power button to turn on the robot. 1.

Place the robot on the charging base to start charging. We recommend that you

charge the robot for at least 6 hours before using it for the ﬁrst time.

Start / Pause

10.

Please do not place the charging base on carpets or soft ﬂoors and keep the area dry.

Remove the mopping cloth holder when the robot is under the charging state.

To make sure the robot is always ready for use, we suggest that you keep the robot charged on

the charging base. For long-term storage, remove the robot from the base and store it in a cool &

dry place.

If the robot is not used for more than 3 months, allow it to get charged for at least 12 hours

before using.

To preserve the battery lifespan, we suggest you fully charge the battery at least once every

six months.

The robot will not start to clean if the battery level is too low, please charge it before starting to clean.

During the cleaning, the machine will automatically return to recharge when the battery energy is

running low; after it is fully charged, it will go back to where it left o and resume cleaning.

The robot will enter sleep mode when it is in standby mode for more than 10 minutes. In sleep

mode, press any key to wake up the robot vacuum.

Under special circumstances (such as power depletion, robot vacuum jamming, etc.), the robot

vacuum may not be able to recharge automatically. Please manually place the robot vacuum back

to the charging base.

Do not immerse the robot in water. Doing so may damage the equipment, causing short-circuit

or current leakage.

NOTE

Midea M6 User Manual

Other manuals for Midea M6