Type 2: Underneath existing work top
(When fitting beneath a work top)
In most modern fitted kitchens there is only one single
work top under which cabinets and electrical appliances
are fitted. In this case remove the work top of the
dishwasher by unscrewing the screws under the rear edge
of the top (a).
After removing the work top, the screws must be screwed again under the rear edge
of the top (b).
Attention
a
a
b
b
15
Selecting the best location for the dishwasher
The installation position of the dishwasher should be near the existing inlet and drain
hose and power socket.
Illustrations of cabinet dimensions and installation position of the dishwasher.
1. Less than 5 mm between the top of dishwasher and cabinet and the outer door
aligned to cabinet.
90 °
90 °
580mm
820mm
100
Electrical, drain
and water supply
line connection
Space between cabinet
bottom and floor
600 mm(for 60cm model)
450 mm(for 45cm model)
80
2. If dishwasher is installed at the corner of the cabinet,
there should be some space when the door is opened.
Depending on where your electrical outlet is, you may
need tocut a hole in the opposite cabinet side.
Dishwasher
Door of
dishwasher
Cabinet
Minimum space
of 50mm
To Next Page
Loading...
Need help?
General
