Water supply and drainage
Connection to the water supply
Connect the cold water supply hose to the
3/4 inch connection thread and make sure
the connection is tight.
If the water hoses are new or haven't
been used for a long time, let the
water run to make sure the water is
clear. This precaution is necessary to
avoid the risk of blocking the water
inlet and damaging the device.
usually supplied
hose
security
supply hose
About the safety supply hose
The safety supply hose has double walls. The hose system serves to interrupt the water
supply in the event of a hose burst and when the space between the supply hose itself and
the outer corrugated hose is full of water.
WARNING
The hose on the sink faucet can burst if it is connected to the same water supply as the
washing machine. If your sink has such a hose, it is recommended that
you take it off and block the drain.
Connecting the safety supply hose
1.Remove the safety supply hose from the container on the back of the washing machine.
2.Tighten the supply hose bolts to the 3/4 inch threaded faucet.
3.Before starting the washing machine, open the water all the way.
Disconnecting the safety supply hose
1.Turn off the water.
2.Disconnect the safety supply hose from the faucet.
18
To Next Page
Loading...
Need help?
General
