Miele CS 1212 User Manual

... after the cooking zone has been
switched on for a few seconds L
appears in the display.
The safety lock has been activated (see
"Safety lock").
... H appears in one of the cooking
zone displays.
The overheating protection mechanism
has been triggered (see "Overheating
protection").
... F appears in one of the cooking
zone displays.
The temperature sensor for that
cooking zone is defective. This cooking
zone can no longer be used. Call the
Service Department.
... one or more cooking zones has
switched itself off automatically.
The safety switch-off feature or the
overheating protection mechanism has
been triggered (see "Safety switch-off"
and "Overheating protection").
... the Booster has deactivated early
automatically.
The overheating protection mechanism
has been triggered (see "Overheating
protection").
... the cooking zone is not working in
the usual way at the power level set.
The overheating protection mechanism
has been triggered (see "Overheating
protection").
... the food in the pan hardly heats up
or does not heat up at all when the
Auto heat-up function is switched on.
This could be because:
–
there is too much food in the pan.
–
the pan is not conducting heat
properly.
Select a higher continued cooking
setting next time or start cooking at the
highest setting and then turn down to a
lower setting manually later on.
... the cooling fan continues to run
after the appliance has been
switched off.
This is not a fault. The fan will continue
running until the appliance has cooled
down. It will then switch itself off
automatically.
Problem solving guide
33

Miele CS 1212 Specifications

General

Brand	Miele
Model	CS 1212
Category	Hob
Language	English