Problem solving guide
78
Water inlet fault
Problem Cause and remedy
The / indicator
light flashes on and off.
and appear altern-
ately on the time dis-
play.
The stopcock is closed.
Open the stopcock fully.
The dishwasher stops
during a programme.
The / indicator
light is flashing.
The fault number or
appears in the dis-
play.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water inlet is restricted.
Open the stopcock fully and start the programme
again.
Clean the filter in the water inlet (see “Cleaning
and care” – Cleaning the filter in the water inlet”).
The water-connection pressure is lower than
50kPa.
Seek professional advice.
The on-site connection for the water drainage may
be too low and you will need to vent the water
drainage (see “Installation – Water drainage”).
The dishwasher stops
during a programme.
Fault number 8 ap-
pears in the time dis-
play.
A technical fault has occurred.
Switch the dishwasher off.
Close the stopcock.
Call the Miele Customer Service Department.
To Next Page
Loading...
Need help?
General
