Product and Cut-out Dimensions Page 1 of 2
H 4844 BP Chef Series Single 30
”
Classic Design DS 4045 Signature Handle
H 4846 BP Chef Series Single 30” Oven – Europa Design DS 4042 Square Handle
Proud Tall Cabinet Installation
A – Vent cut-out (min. 24" ² / 150 cm ²) possible at rear or platform of cabinet
B – Cut-out for power cord (min. 1" 2 / 3 cm2)
C – 6 ft. (1.8 m) flexible power cord consisting of 4 wires ready for connection
to a dedicated 3 pole, 4 wire grounded power supply:
208 V, 60 Hz, 30 A fuse rating
240 V, 60 Hz, 30 A fuse rating
Ensure that the power outlet is accessible after installation
The silver data plate is located along the front side of the oven with the door open.
Notes
The oven must be installed into cabinetry and be supported from underneath.
Miele appliances can be installed flush or proud. Discuss your installation requirements with your architect, designer
and installer. Cabinet depth for flush installation is 25” also the inside edges of the rough opening must be finished.
All installations must be done in accordance with local codes.
Drawing is not to scale Specification Sheets OJS 05252012
To Next Page
Need help?
General